控制器、服務器和客戶機三者之間的連接有兩種情況：一是DCS控制器有以太網接口，三者用以太網交換機來連接。交換機有多種端口，每個端口數據傳輸速率可以不等。端口數量由連接的計算機臺數決定。交換機主要指標是背板寬度和存儲器大小。如果采用以太網電纜如10BASE、100BASE等的速率都可傳輸，如采用5類線只能是10BASE。在圖2以太網的連接是星型。使用離散的
電纜將每臺計算機連接到中央連接點，通常稱為網絡集線器。每臺計算機使用獨立電纜，連接失敗只影響有關的單臺計算機，其他計算機可繼續運行。如果各臺機器適配器速率相同，以太網星型連接通常使用10BaseT電纜。
Two kinds of hardware of c/s structure network, usually called client PC and server. The client PC is in the central control room and the server is in a safe place. The causes of DCS operation station crash are complicated. This article is limited to analyzing the causes of the crash caused by the c/s structure. There are two cases:There are two kinds of connections among controller, server and client: one is that DCs controller has Ethernet interface, and the three are connected by Ethernet switch. The switch has a variety of ports, and the data transmission rate of each port can be different. The number of ports is determined by the number of computers connected. The main indicators of the switch are the backplane width and memory size. If Ethernet cables such as 10base and 100base are used, the rate can be transmitted. If category 5 cable is used, it can only be 10base. In Figure 2, the Ethernet connection is star shaped. Use discrete
Cables connect each computer to a central connection point, commonly referred to as a network hub. Each computer uses an independent cable. The connection failure only affects the relevant single computer, and other computers can continue to run. If each machine has the same adapter rate, the Ethernet star connection usually uses a 10baset cable.
客服1